Eine Plattform für die Wissenschaft: Bauingenieurwesen, Architektur und Urbanistik
MODIFIKASI ALAT PENCABUT PAKU PADA DINDING BANGUNAN
Nails are hard pointed metal, generally made of steel, used to attach two materials by penetrating both. Nails are generally blown on materials using a hammer or nail gun that is driven by compressed air or a small explosive impulse. Attachment by spikes occurs in the presence of friction forces in the vertical direction and force of force in the lateral direction. The tip of the nail is sometimes bent to prevent the spikes coming out. One of the purposes of making this tool is as an alternative tool that has been used only to open the axle, bearing and the other but can be used to remove the spikes with little modification. From the results of the discussion and can be the force of the tensile rod on the spikes F = 4.5 kg), shear stresses that occur in the shaft thread (tg=0,542 kg/cm2), Initial shear Stress (tg=30,5 kg/cm2), yield bend that occurs in the rotary lever (sb=42,993 kg/cm2). then the modification of the nail-pulling device on the wall of the building can be used properly. Keywords: Nails, Lateral Directions, Yield
MODIFIKASI ALAT PENCABUT PAKU PADA DINDING BANGUNAN
Nails are hard pointed metal, generally made of steel, used to attach two materials by penetrating both. Nails are generally blown on materials using a hammer or nail gun that is driven by compressed air or a small explosive impulse. Attachment by spikes occurs in the presence of friction forces in the vertical direction and force of force in the lateral direction. The tip of the nail is sometimes bent to prevent the spikes coming out. One of the purposes of making this tool is as an alternative tool that has been used only to open the axle, bearing and the other but can be used to remove the spikes with little modification. From the results of the discussion and can be the force of the tensile rod on the spikes F = 4.5 kg), shear stresses that occur in the shaft thread (tg=0,542 kg/cm2), Initial shear Stress (tg=30,5 kg/cm2), yield bend that occurs in the rotary lever (sb=42,993 kg/cm2). then the modification of the nail-pulling device on the wall of the building can be used properly. Keywords: Nails, Lateral Directions, Yield
MODIFIKASI ALAT PENCABUT PAKU PADA DINDING BANGUNAN
Fatoni, Zulkarnain (Autor:in)
10.06.2018
doi:10.36767/turbulen.v1i1.349
TURBULEN Jurnal Teknik Mesin; Vol 1, No 1 (June 2018) ; Jurnal Turbulen; Vol 1, No 1 (June 2018) ; 2656-0186 ; 2621-3354 ; 10.36767/turbulen.v1i1
Aufsatz (Zeitschrift)
Elektronische Ressource
Englisch
DDC:
690
PERBANDINGAN PERILAKU STRUKTUR DINDING TERKEKANG DAN RANGKA DINDING PENGISI PADA BANGUNAN 4 LANTAI
DOAJ | 2023
|Evaluasi Termal Vertical Greenery System Tipe Green Facade pada Dinding Bangunan
DOAJ | 2021
|Analisis Dinding Geser pada Desain Bangunan Gedung Bertingkat yang Tidak Beraturan
DOAJ | 2021
|Evaluasi Termal Vertical Greenery System Tipe Green Facade pada Dinding Bangunan
BASE | 2021
|