Eine Plattform für die Wissenschaft: Bauingenieurwesen, Architektur und Urbanistik
Eine Plattform für die Wissenschaft: Bauingenieurwesen, Architektur und Urbanistik
Re-deposition of ITER-grade Be on plasma gun facility QSPA-Be: Characterization & plasma cleaning
Studies of contaminants obtained by spraying ITER-grade Be on a quasi-stationary plasma gun facility QSPA-Be are presented. Contaminating films, consisting mainly of Be and O in approximately equal proportions, were deposited on substrates of quartz, sapphire, single crystalline silicon (SC-Si) and NaCl crystal. Characterization of the deposits was performed using SEM, XPS, EBS, AFM, SE, TEM&SAED and micro-interferometry showing polycrystalline BeO films similar as found in JET-ILW. Films on SC-Si and NaCl were used to characterize their composition and morphology. The cleaning rates in the 81.36 MHz RF discharges in He or D2 at 2 Pa were measured on the SC-Si target. The measured etching rate of the deposited films was several times higher than the rate calculated from the theoretical value of beryllium oxide sputtering yield. Test cleaning of these contaminants was carried out in a capacitively coupled RF discharge (CCRF) from the surface of sapphire and quartz plates, which were considered as a mock-ups of the protective window of the first mirror unit (FMU) designed for ITER divertor Thomson scattering diagnostic system (DTS).
Re-deposition of ITER-grade Be on plasma gun facility QSPA-Be: Characterization & plasma cleaning
Studies of contaminants obtained by spraying ITER-grade Be on a quasi-stationary plasma gun facility QSPA-Be are presented. Contaminating films, consisting mainly of Be and O in approximately equal proportions, were deposited on substrates of quartz, sapphire, single crystalline silicon (SC-Si) and NaCl crystal. Characterization of the deposits was performed using SEM, XPS, EBS, AFM, SE, TEM&SAED and micro-interferometry showing polycrystalline BeO films similar as found in JET-ILW. Films on SC-Si and NaCl were used to characterize their composition and morphology. The cleaning rates in the 81.36 MHz RF discharges in He or D2 at 2 Pa were measured on the SC-Si target. The measured etching rate of the deposited films was several times higher than the rate calculated from the theoretical value of beryllium oxide sputtering yield. Test cleaning of these contaminants was carried out in a capacitively coupled RF discharge (CCRF) from the surface of sapphire and quartz plates, which were considered as a mock-ups of the protective window of the first mirror unit (FMU) designed for ITER divertor Thomson scattering diagnostic system (DTS).
Re-deposition of ITER-grade Be on plasma gun facility QSPA-Be: Characterization & plasma cleaning
A.M. Dmitriev (Autor:in) / A.G. Razdobarin (Autor:in) / L.A. Snigirev (Autor:in) / D.I. Elets (Autor:in) / I.M. Bukreev (Autor:in) / N.A. Babinov (Autor:in) / L.A. Varshavchik (Autor:in) / E.E. Mukhin (Autor:in) / D.S. Samsonov (Autor:in) / S. Yu. Tolstyakov (Autor:in)
2022
Aufsatz (Zeitschrift)
Elektronische Ressource
Unbekannt
Metadata by DOAJ is licensed under CC BY-SA 1.0
SOLPS-ITER modeling of deuterium throughput impact on the ITER SOL plasma
| DOAJ | 2023
SOLPS-ITER simulations of the ITER divertor with improved plasma-facing component geometry
| Elsevier | 2025