Eine Plattform für die Wissenschaft: Bauingenieurwesen, Architektur und Urbanistik
Eine Plattform für die Wissenschaft: Bauingenieurwesen, Architektur und Urbanistik
Development and Validation of a New Calibration Model for Diviner 2000® Probe Based on Soil Physical Attributes
This study aimed to develop a new model, valid for soil with and without expandable characters, to estimate volumetric soil water content (θ) from readings of scaled frequency (SF) acquired with the Diviner 2000® sensor. The analysis was carried out on six soils collected in western Sicily, sieved at 5 mm, and repacked to obtain the maximum and minimum bulk density (ρb). During an air-drying process SF values, the corresponding gravimetric soil water content (U) and ρb were monitored. In shrinking/swelling clay soils, due to the contraction process, the variation of dielectric permittivity was affected by the combination of the mutual proportions between the water volumes and the air present in the soil. Thus, to account for the changes of ρb with U, the proposed model assumed θ as the dependent variable being SF and ρb the independent variables; then the model’s parameters were estimated based on the sand and clay fractions. The model validation was finally carried out based on data acquired in undisturbed monoliths sampled in the same areas. The estimated θ, θestim, was generally close to the corresponding measured, θmeas, with Root Mean Square Errors (RMSE) generally lower than 0.049 cm3 cm−3, quite low Mean Bias Errors (MBE), ranging between −0.028 and 0.045 cm3 cm−3, and always positive Nash-Sutcliffe Efficiency index (NSE), confirming the good performance of the model.
Development and Validation of a New Calibration Model for Diviner 2000® Probe Based on Soil Physical Attributes
This study aimed to develop a new model, valid for soil with and without expandable characters, to estimate volumetric soil water content (θ) from readings of scaled frequency (SF) acquired with the Diviner 2000® sensor. The analysis was carried out on six soils collected in western Sicily, sieved at 5 mm, and repacked to obtain the maximum and minimum bulk density (ρb). During an air-drying process SF values, the corresponding gravimetric soil water content (U) and ρb were monitored. In shrinking/swelling clay soils, due to the contraction process, the variation of dielectric permittivity was affected by the combination of the mutual proportions between the water volumes and the air present in the soil. Thus, to account for the changes of ρb with U, the proposed model assumed θ as the dependent variable being SF and ρb the independent variables; then the model’s parameters were estimated based on the sand and clay fractions. The model validation was finally carried out based on data acquired in undisturbed monoliths sampled in the same areas. The estimated θ, θestim, was generally close to the corresponding measured, θmeas, with Root Mean Square Errors (RMSE) generally lower than 0.049 cm3 cm−3, quite low Mean Bias Errors (MBE), ranging between −0.028 and 0.045 cm3 cm−3, and always positive Nash-Sutcliffe Efficiency index (NSE), confirming the good performance of the model.
Development and Validation of a New Calibration Model for Diviner 2000® Probe Based on Soil Physical Attributes
Giuseppe Provenzano (Autor:in) / Giovanni Rallo (Autor:in) / Ceres Duarte Guedes Cabral de Almeida (Autor:in) / Brivaldo Gomes de Almeida (Autor:in)
2020
Aufsatz (Zeitschrift)
Elektronische Ressource
Unbekannt
Metadata by DOAJ is licensed under CC BY-SA 1.0
Laboratory and Field Calibration of the Diviner 2000 Probe in Two Types of Soil
| British Library Online Contents | 2014
| British Library Online Contents | 2016
| Engineering Index Backfile | 1928
| British Library Conference Proceedings | 2006