Eine Plattform für die Wissenschaft: Bauingenieurwesen, Architektur und Urbanistik
Eine Plattform für die Wissenschaft: Bauingenieurwesen, Architektur und Urbanistik
Validation of SOLPS-ITER and EDGE2D-EIRENE simulations for H, D, and T JET ITER-like wall low-confinement mode plasmas
Both experiments and simulations with SOLPS-ITER and EDGE2D-EIRENE show that the onset of detachment for the low-field side (LFS) divertor – defined here as the line-averaged upstream density (〈ne〉edge) at which the plasma flux to the LFS target (ILFS−plate) starts to decrease with increasing 〈ne〉edge – is independent of the isotope mass. However, there are three major simulation-experiment discrepancies: (i) the absolute values of ILFS−plate and the electron density (ne) in the LFS divertor at the onset of detachment are significantly lower in simulations, i.e., approximately a factor of 2 for ILFS−plate and a factor of 3-4 for ne; (ii) the degree of detachment – defined here as the difference between ILFS−plate at the onset of detachment and at an 〈ne〉edge value close to the density limit – is smaller in simulations compared to experiments; and (iii) the experimentally observed larger degree of detachment for D and T plasmas compared to H plasmas cannot be clearly distinguished from the simulation results. There are strong indications that discrepancy (i) is to a large extent caused by neglecting Lyman-opacity effects in our simulations. The simulations predict a similar net volumetric recombination source for all isotopes due to the fact that molecule-activated recombination (MAR) compensates for the reduced electron–ion recombination (EIR) for H, whereas MAR is negligible for D and T. This similar net volumetric recombination source for all isotopes leads to an isotope-independent degree of detachment in simulations. An analysis of the Balmer-α and Balmer-γ emission confirms the underestimate of MAR in simulations (especially for D and T) for the JET metallic wall, which was previously observed for devices with a carbon wall. The underestimate of MAR is an important cause for discrepancy (ii) and the fact that there is a stronger underestimate of MAR for D and T than for H explains discrepancy (iii). Extending the plasma grid to the vessel wall increases ILFS−plate and ne at the onset of detachment by 25%, and the EIR source increases by 80% in detached conditions. Hence, while the extended grid results are closer to the experimental observations, the previously described qualitative discrepancies still persist.
Validation of SOLPS-ITER and EDGE2D-EIRENE simulations for H, D, and T JET ITER-like wall low-confinement mode plasmas
Both experiments and simulations with SOLPS-ITER and EDGE2D-EIRENE show that the onset of detachment for the low-field side (LFS) divertor – defined here as the line-averaged upstream density (〈ne〉edge) at which the plasma flux to the LFS target (ILFS−plate) starts to decrease with increasing 〈ne〉edge – is independent of the isotope mass. However, there are three major simulation-experiment discrepancies: (i) the absolute values of ILFS−plate and the electron density (ne) in the LFS divertor at the onset of detachment are significantly lower in simulations, i.e., approximately a factor of 2 for ILFS−plate and a factor of 3-4 for ne; (ii) the degree of detachment – defined here as the difference between ILFS−plate at the onset of detachment and at an 〈ne〉edge value close to the density limit – is smaller in simulations compared to experiments; and (iii) the experimentally observed larger degree of detachment for D and T plasmas compared to H plasmas cannot be clearly distinguished from the simulation results. There are strong indications that discrepancy (i) is to a large extent caused by neglecting Lyman-opacity effects in our simulations. The simulations predict a similar net volumetric recombination source for all isotopes due to the fact that molecule-activated recombination (MAR) compensates for the reduced electron–ion recombination (EIR) for H, whereas MAR is negligible for D and T. This similar net volumetric recombination source for all isotopes leads to an isotope-independent degree of detachment in simulations. An analysis of the Balmer-α and Balmer-γ emission confirms the underestimate of MAR in simulations (especially for D and T) for the JET metallic wall, which was previously observed for devices with a carbon wall. The underestimate of MAR is an important cause for discrepancy (ii) and the fact that there is a stronger underestimate of MAR for D and T than for H explains discrepancy (iii). Extending the plasma grid to the vessel wall increases ILFS−plate and ne at the onset of detachment by 25%, and the EIR source increases by 80% in detached conditions. Hence, while the extended grid results are closer to the experimental observations, the previously described qualitative discrepancies still persist.
Validation of SOLPS-ITER and EDGE2D-EIRENE simulations for H, D, and T JET ITER-like wall low-confinement mode plasmas
N. Horsten (Autor:in) / M. Groth (Autor:in) / V.-P. Rikala (Autor:in) / B. Lomanowski (Autor:in) / A.G. Meigs (Autor:in) / S. Aleiferis (Autor:in) / X. Bonnin (Autor:in) / G. Corrigan (Autor:in) / W. Dekeyser (Autor:in) / R. Futtersack (Autor:in)
2025
Aufsatz (Zeitschrift)
Elektronische Ressource
Unbekannt
Metadata by DOAJ is licensed under CC BY-SA 1.0
| Elsevier | 2025
Stabilization of EMC3-EIRENE for detachment conditions and comparison to SOLPS-ITER
| DOAJ | 2019
Plasma edge simulations including realistic wall geometry with SOLPS-ITER
| DOAJ | 2021