Eine Plattform für die Wissenschaft: Bauingenieurwesen, Architektur und Urbanistik
Eine Plattform für die Wissenschaft: Bauingenieurwesen, Architektur und Urbanistik
Compositionally graded Ti6Al4V+TiC made by direct laser fabrication using powder and wire
AbstractTi6Al4V reinforced with TiC has been fabricated as compositionally graded material by direct laser fabrication using TiC powder and Ti6Al4V wire which were fed simultaneously into the laser focal point. The microstructure along the length of the sample has been characterised using X-ray diffraction and scanning electron microscopy. The results show that the composition along the length changes as expected from the imposed changes in feed rate when allowance is made for the different capture efficiency for the powder and the wire. Some unmelted TiC has been observed in regions where the TiC fraction was high, but along most of the length of the samples TiC was completely melted and formed primary TiC, eutectic TiC and secondary TiC. Some preliminary tribological properties of the compositionally graded material were obtained using a sliding wear test which showed that the tribological properties of Ti6Al4V are improved by the reinforced TiC particles with the optimum frictional behaviour being found with approximately 24vol% of TiC.
Compositionally graded Ti6Al4V+TiC made by direct laser fabrication using powder and wire
AbstractTi6Al4V reinforced with TiC has been fabricated as compositionally graded material by direct laser fabrication using TiC powder and Ti6Al4V wire which were fed simultaneously into the laser focal point. The microstructure along the length of the sample has been characterised using X-ray diffraction and scanning electron microscopy. The results show that the composition along the length changes as expected from the imposed changes in feed rate when allowance is made for the different capture efficiency for the powder and the wire. Some unmelted TiC has been observed in regions where the TiC fraction was high, but along most of the length of the samples TiC was completely melted and formed primary TiC, eutectic TiC and secondary TiC. Some preliminary tribological properties of the compositionally graded material were obtained using a sliding wear test which showed that the tribological properties of Ti6Al4V are improved by the reinforced TiC particles with the optimum frictional behaviour being found with approximately 24vol% of TiC.
Compositionally graded Ti6Al4V+TiC made by direct laser fabrication using powder and wire
Wang, F. (Autor:in) / Mei, J. (Autor:in) / Wu, Xinhua (Autor:in)
02.06.2006
7 pages
Aufsatz (Zeitschrift)
Elektronische Ressource
Englisch
Compositionally graded Ti6Al4V+TiC made by direct laser fabrication using powder and wire
| British Library Online Contents | 2007
Laser fabrication of Ti6Al4V/TiC composites using simultaneous powder and wire feed
| British Library Online Contents | 2007
| British Library Online Contents | 2011
Compositionally graded magnetic-nonmagnetic bimetallic structure using laser engineered net shaping
| British Library Online Contents | 2018