Axial compressive behavior and model analysis of BFRP-jacketed corroded and pre-damaged circular reinforced concrete columns: Fid-Bau Portal

Axial compressive behavior and model analysis of BFRP-jacketed corroded and pre-damaged circular reinforced concrete columns

Hou, Chunxu / Ma, Gao / Hwang, Hyeon-Jong / Zhu, Deju / Zhou, Yangquan

Abstract

Abstract Corrosion of steel reinforcements degrades the structural performance of reinforced concrete (RC) columns under static and seismic loads. Such corroded RC columns are usually retrofitted with fiber-reinforced polymer (FRP). However, existing studies on the retrofitting of RC columns with corrosion and load-induced damage are limited. To confirm the effectiveness of basalt FRP (BFRP) jacketing on the compressive behavior of corroded and pre-damaged RC columns, this study performed axial compression tests on eleven circular RC columns. The columns were fabricated, corroded, pre-damaged, and then jacketed with BFRP composites and reloaded to investigate the effects of BFRP layer number, corrosion ratio, and pre-damage degree. When jacketed by BFRP, the ultimate strength and ultimate strain of RC columns increased with BFRP layer numbers, ranging from 5% to 98% and 448% to 926%, respectively. Further, the ultimate strength and elastic modulus of the jacketed RC columns decreased with the increase in pre-damage degrees and corrosion ratios, while the ultimate strain was little affected. Buckling and corrosion of longitudinal bars significantly reduced the bar stresses at the ultimate state of BFRP-jacketed RC columns and resulted in local rupture of BFRP. This adverse effect became more pronounced as the corrosion ratio increased, but was alleviated by BFRP jacketing. On the other hand, a refined rebar stress-strain model was developed by addressing the effects of buckling, corrosion, and lateral confinement. Further, a feasible constitutive model for corroded hoop-confined columns was determined by validating the existing test results. Finally, models for the ultimate strength, ultimate strain, and stress-strain response of BFRP-jacketed corroded and pre-damaged RC columns were developed.

Highlights • BFRP jacketing improved the axial compressive behavior of corroded and pre-damaged RC columns. • Increasing the corrosion ratios and pre-damage degrees decreased the strength and elastic modulus. • The effects of buckling, corrosion, and BFRP confinement on rebar ultimate stress were evaluated. • A stress-strain model was developed for BFRP-jacketed corroded and pre-damaged RC columns.