Workability studies on sintered Cu–10SiC preforms during cold axial upsetting: Fid-Bau Portal

Workability studies on sintered Cu–10SiC preforms during cold axial upsetting

Sumathi, M. / Selvakumar, N. / Narayanasamy, R.

Highlights ► Cold axial upsetting tests were performed on Cu–10SiC preforms. ► Analyzed formability stress index with respect to axial strain. ► Curve fitting techniques were tried to stress ratio parameters with R. ► During deformation three different densification mechanisms have been studied.

Abstract An investigation has been carried out for the determination of the workability behavior of Cu–10SiC composite under triaxial stress state condition. Cylindrical preforms with three different initial preform densities (namely 85%, 90% and 95% of the theoretical density), possessing aspect ratios of 0.60, 0.50 and 0.40 were prepared using a die and punch assembly with a 1.0MN capacity Universal Testing Machine (UTM). Then the preforms were sintered in a muffle furnace at a temperature of 850±10°C for a period of 1h. Based on the experimental results the phenomena like axial strain (εz), various stress ratio parameters, namely (σθ/σeff) and (σm/σeff), the formability stress index (βσ) under triaxial stress state conditions were systematically analysed. It was found that lower initial aspect ratio with higher initial relative density preforms exhibited enhanced formability stress index compared to higher aspect ratio with lower initial relative density preforms.