Eine Plattform für die Wissenschaft: Bauingenieurwesen, Architektur und Urbanistik
Eine Plattform für die Wissenschaft: Bauingenieurwesen, Architektur und Urbanistik
Foreign-object damage and high-cycle fatigue: Role of microstructure in Ti-6Al-4V
The objective of this study was to evaluate the influence of microstructure on the susceptibility to high-cycle fatigue (HCF) failure in Ti-6Al-4V following foreign-object damage (FOD), specifically by comparing a fine-grained bi-modal microstructure with a coarse grained lamellar microstructure. FOD was simulated by high-velocity impacts of steel spheres on a flat surface. This caused a marked reduction in the smooth-bar fatigue strength in both microstructures, primarily because of the premature initiation of fatigue cracking resulting from the stress concentration associated with damage site and FOD-induced microcracking. The FOD-initiated microcracks were found to be of a size comparable with microstructural dimensions, and on subsequent fatigue loading were seen to propagate at applied stress-intensity levels below Delta K(similar to)1 MPa m1/2, i.e. a factor of roughly two less than the 'worst-case' threshold stress-intensity range in Ti-6Al-4V for a crack of large size compared to microstructural dimensions (a 'continuum-sized' crack). A rational approach against HCF failures from such microcracks is proposed for the fine-grained bi-modal microstructure based on the Kitagawa-Takahashi diagram. For the bi-modal microstructure, the Kitagawa-Takahashi diagram provides a basis for describing the threshold conditions for FOD-induced HCF failures, in terms of the stress concentration corrected smooth-bar fatigue limit for small crack sizes and the worst-case threshold for larger continuum-sized cracks. However, this approach was found to be less applicable to the coarse grained lamellar microstructure, primarily because of low small-crack growth resistance relative to its higher smooth-bar fatigue limit.
Foreign-object damage and high-cycle fatigue: Role of microstructure in Ti-6Al-4V
The objective of this study was to evaluate the influence of microstructure on the susceptibility to high-cycle fatigue (HCF) failure in Ti-6Al-4V following foreign-object damage (FOD), specifically by comparing a fine-grained bi-modal microstructure with a coarse grained lamellar microstructure. FOD was simulated by high-velocity impacts of steel spheres on a flat surface. This caused a marked reduction in the smooth-bar fatigue strength in both microstructures, primarily because of the premature initiation of fatigue cracking resulting from the stress concentration associated with damage site and FOD-induced microcracking. The FOD-initiated microcracks were found to be of a size comparable with microstructural dimensions, and on subsequent fatigue loading were seen to propagate at applied stress-intensity levels below Delta K(similar to)1 MPa m1/2, i.e. a factor of roughly two less than the 'worst-case' threshold stress-intensity range in Ti-6Al-4V for a crack of large size compared to microstructural dimensions (a 'continuum-sized' crack). A rational approach against HCF failures from such microcracks is proposed for the fine-grained bi-modal microstructure based on the Kitagawa-Takahashi diagram. For the bi-modal microstructure, the Kitagawa-Takahashi diagram provides a basis for describing the threshold conditions for FOD-induced HCF failures, in terms of the stress concentration corrected smooth-bar fatigue limit for small crack sizes and the worst-case threshold for larger continuum-sized cracks. However, this approach was found to be less applicable to the coarse grained lamellar microstructure, primarily because of low small-crack growth resistance relative to its higher smooth-bar fatigue limit.
Foreign-object damage and high-cycle fatigue: Role of microstructure in Ti-6Al-4V
Peters, J.O. (Autor:in) / Ritchie, R.O. (Autor:in)
International Journal of Fatigue ; 23 ; S413-S421
2001
9 Seiten, 26 Quellen
Aufsatz (Zeitschrift)
Englisch
Foreign-object damage and high-cycle fatigue: role of microstructure in Ti-6Al-4V
| British Library Online Contents | 2001
Foreign-object damage and high-cycle fatigue of Ti-6Al-4V
| British Library Online Contents | 2001
High cycle fatigue limit stresses for airfoils subjected to foreign object damage
| British Library Online Contents | 2003
High cycle fatigue behavior of Ti-6Al-4V with simulated foreign object damage
| British Library Online Contents | 2001
On the application of the Kitagawa-Takahashi diagram to foreign-object damage and high-cycle fatigue
| British Library Online Contents | 2002