Eine Plattform für die Wissenschaft: Bauingenieurwesen, Architektur und Urbanistik
Eine Plattform für die Wissenschaft: Bauingenieurwesen, Architektur und Urbanistik
Understanding the impulse response method applied to concrete bridge decks
The Impulse Response (IR) method is a well-established form of non-destructive testing (NDT) where the dynamic response of an element resulting from an impact event (hammer blow) is measured with a geophone to make conclusions about the element's integrity, stiffness, and/or support conditions. The existing ASTM Standard C1740-10 prescribes a set of parameters that can be used to evaluate the conditions above. These parameters are computed from the so-called 'mobility' spectrum which is obtained by dividing the measured bridge deck response by the measured impact force in the frequency domain. While applying the test method in the laboratory as well as on an actual in-service concrete bridge deck, the authors of this paper observed several limitations that are presented and discussed in this paper. In order to better understand the underlying physics of the IR method, a Finite Element (FE) model was created. Parameters prescribed in the Standard were then computed from the FE data and are discussed. One main limitation appears to be the use of a fixed upper frequency of 800 Hz. Test data from the real bridge deck as well as the FE model both show that most energy is found above that limit. This paper presents and discusses limitations of the ASTM Standard found by the authors and suggests ways for improving it.
Understanding the impulse response method applied to concrete bridge decks
The Impulse Response (IR) method is a well-established form of non-destructive testing (NDT) where the dynamic response of an element resulting from an impact event (hammer blow) is measured with a geophone to make conclusions about the element's integrity, stiffness, and/or support conditions. The existing ASTM Standard C1740-10 prescribes a set of parameters that can be used to evaluate the conditions above. These parameters are computed from the so-called 'mobility' spectrum which is obtained by dividing the measured bridge deck response by the measured impact force in the frequency domain. While applying the test method in the laboratory as well as on an actual in-service concrete bridge deck, the authors of this paper observed several limitations that are presented and discussed in this paper. In order to better understand the underlying physics of the IR method, a Finite Element (FE) model was created. Parameters prescribed in the Standard were then computed from the FE data and are discussed. One main limitation appears to be the use of a fixed upper frequency of 800 Hz. Test data from the real bridge deck as well as the FE model both show that most energy is found above that limit. This paper presents and discusses limitations of the ASTM Standard found by the authors and suggests ways for improving it.
Understanding the impulse response method applied to concrete bridge decks
Clem, D.J. (Autor:in) / Popovics, J.S. (Autor:in) / Schumacher, T. (Autor:in) / Oh, T. (Autor:in) / Ham, S. (Autor:in) / Wu, D. (Autor:in)
2013
8 Seiten, 7 Bilder, 7 Quellen
Aufsatz (Konferenz)
Englisch
Impulse radar reflection waveforms of simulated reinforced concrete bridge decks
| Tema Archiv | 1994
Impulse radar evaluation of reinforced concrete bridge decks [2456-18]
| British Library Conference Proceedings | 1995
Finishing concrete bridge decks
| Engineering Index Backfile | 1963
Nondestructive testing of bridge decks and tunnel linings using impulse-response
| Tema Archiv | 2009