A platform for research: civil engineering, architecture and urbanism
A platform for research: civil engineering, architecture and urbanism
Deformation and fatigue behavior of hot dip galvanized coatings
This paper reports on the results of a study of the effect of static and dynamic stresses on hot dip galvanized coatings on SAE 1020 steel substrates. Galvanizing was performed using baths maintained at 450 degree C, the zinc containing 0.16% Ti and 0.02% Fe and with Al and Ni in the ranges 0-0.20% and 0-0.30%, respectively. Static three-point bend tests were conducted with applied stresses in the range 428-790 MPa. Dynamic bend-fatigue tests involved stresses in the range 228-578 MPa at a cyclic frequency of 0.25 Hz for up to 700 cycles. The total crack density in the coatings was measured before and after the tests using light optical and electron microscopy. The results showed that the crack density increased as the applied stress increased and crack propagation was promoted perpendicular to the substrate. The number of cycles had no effect on the crack density and propagation at stresses lower than 386 MPa. At higher stresses the number of applied cycles contributed only to crack propagation. It was concluded that the best bath composition for preventing fatigue crack propagation is one that minimized the formation of thinner brittle layers in the galvanized coatings.
Deformation and fatigue behavior of hot dip galvanized coatings
This paper reports on the results of a study of the effect of static and dynamic stresses on hot dip galvanized coatings on SAE 1020 steel substrates. Galvanizing was performed using baths maintained at 450 degree C, the zinc containing 0.16% Ti and 0.02% Fe and with Al and Ni in the ranges 0-0.20% and 0-0.30%, respectively. Static three-point bend tests were conducted with applied stresses in the range 428-790 MPa. Dynamic bend-fatigue tests involved stresses in the range 228-578 MPa at a cyclic frequency of 0.25 Hz for up to 700 cycles. The total crack density in the coatings was measured before and after the tests using light optical and electron microscopy. The results showed that the crack density increased as the applied stress increased and crack propagation was promoted perpendicular to the substrate. The number of cycles had no effect on the crack density and propagation at stresses lower than 386 MPa. At higher stresses the number of applied cycles contributed only to crack propagation. It was concluded that the best bath composition for preventing fatigue crack propagation is one that minimized the formation of thinner brittle layers in the galvanized coatings.
Deformation and fatigue behavior of hot dip galvanized coatings
Camurri, Carlos P. (author) / Raul Benavente, G. (author) / Isidoro Roa, S. (author) / Claudia Carrasco, C. (author)
Materials Characterization ; 55 ; 203-210
2005
8 Seiten, 9 Quellen
Article (Journal)
English
Coatings Basics - Coating Newly Galvanized Steel
| British Library Online Contents | 1995
Corrosion Behavior of Galvanized Steel with Organic Coatings Containing Metallic Powders
| British Library Online Contents | 2018
Corrosion Behavior of Galvanized Steel with Organic Coatings Containing Metallic Powders
| British Library Online Contents | 2018
Notch Effect on the Fatigue Behavior of a Hot-Dip Galvanized Structural Steel
| British Library Online Contents | 2015
Effect of deformation on the electrochemical behavior of hot-dip galvanized steel sheets
| British Library Online Contents | 2007