Imperfection sensitivity of externally-pressurized, thin-walled, torispherical-head buckling: Fid-Bau Portal

Imperfection sensitivity of externally-pressurized, thin-walled, torispherical-head buckling

Wang, Haifeng / Yao, Xingan / Li, Lei / Sang, Zhifu / Krakauer, Bruce W.

AbstractThe bottom head in the residential electric water heater tank is an externally-pressurized, thin-walled, torispherical structure. In this paper, the buckling behavior of the bottom head was studied by experimental and finite element analysis (FEA) methods. The shapes of four randomly selected water heater tanks were measured by Computer Aided Inspection (CAI), and hydrostatic tests and strain measurements were performed. The buckling simulations of the tested tanks were carried out by finite element method, and the obtained results were in good agreement with the experimental data. Two parameters, contact imperfection ratio, Rimc, and geometry imperfection ratio, Rimg, were used to quantitatively characterize the magnitudes of the main imperfections in the water heater tank manufacturing process. FEA models, including both contact and geometry imperfections, were used to investigate the buckling pressure of the bottom head. The results show that the geometry imperfection, within the range of ASME Code Ⅷ-2 requirements, has a greater effect on the buckling pressure than the contact imperfection. The obtained curves of buckling pressure versus imperfections can provide guidance for water heater tank design and manufacture.

Highlights•The Computer Aided Inspection technique was used to measure the geometry imperfection.•The buckling strength of the torispherical head was investigated.•The geometry and fabrication imperfection sensitivities of the torispherical head buckling were studied.